Load management 360-degree service

Técnico junto a un vehículo de servicio de Janitza con la inscripción "3 en 1: Sistema de gestión energética, calidad de tensión, monitoreo de corriente residual (RCM)"

No two projects are the same. This makes it all the more important to have a contact person who can provide you with comprehensive advice during all project phases of your load management system. Whether an existing system is to be upgraded or a new project is to be planned from scratch – Janitza electronics supports you from the requirements analysis and the selection of suitable products to the installation and ongoing support of the load management system.

Potential savings

Ícono negro de un diagrama con barras ascendentes sobre fondo transparente

Reduction of expensive peak loads by up to 40%

Ícono negro de una estación de carga para autos eléctricos con cable y enchufe sobre fondo transparente

Reduction of charging costs for electric cars by up to 50%

Ícono negro de un sol con paneles solares sobre fondo transparente

Increase in the efficiency of your PV system in connection with an electric storage unit by up to 100%

Ícono de diagrama negro con una flecha hacia abajo sobre fondo transparente

Reduction of energy consumption and emissions by up to 15%

Ícono minimalista de diagrama negro sobre fondo transparente

Increase in the efficiency level of an electric storage unit by up to 50%

Support in all project phases

Step 1

Requirements analysis and planning

  • Development of the technical concept
  • Creation of a specification sheet
  • Definition of the interfaces
  • Elaboration of a network plan
  • Creation or adaptation of the hardware plans (EPLAN)
  • Planning of the reporting system and configuration of the visualization interface

Step 2

Production and delivery

  • Supply of the required products (energy meters, current transformers, controllers, etc.)
  • If required, construction and supply of switchgear, sub-distribution boards, etc.
  • Supply of the necessary cables and installation material

Step 3

Assembly and installation

  • Set-up of switchgears and sub-distribution boards
  • Extension and conversion of existing switchgear and sub-distribution boards
  • Extension, construction, and installation of cable routes
  • Cable routing and cable connection

Step 4

Setup and commissioning

  • Programming of the controllers and parameterization of the measurement devices
  • Coordination with the manufacturers of the connected devices (inverters, battery storage units, charging stations, etc.) and parameterization, if necessary
  • If necessary, adaptations to existing PLC controllers (Siemens)
  • Commissioning of the overall function, including training courses

Step 5

Service and support

  • Competent technology hotline
  • Technical contact for the entire service area
  • Competent technology hotline
  • Detailed project documentation
  • Automatic e-mail dispatch in case of controller alarms
  • Fast and uncomplicated assistance via remote maintenance

Contactar

Recibir ahora un asesoramiento personalizado

Su solicitud es muy importante para nosotros y le garantizamos una tramitación rápida y profesional.

Icono negro de un mapa de Alemania sobre fondo transparente

Ventas Alemania

Icono negro de un globo sobre fondo transparente

Ventas internacional

Icono negro de socio de soluciones con símbolo de apretón de manos sobre fondo transparente

Socios de ventas Alemania

Icono negro de asistencia técnica con símbolo de auricular sobre fondo transparente

Asistencia técnica para dispositivos existentes